Power and Control

Last night I installed the 48v and the 12/5v power supplies, along with the FastPinball power filter board, Nano Controller, and 3208 I/O board. I found some generic brackets at Lowe’s that fit well enough (since I neglected to order the nice brackets from FAST for some reason). You can also see the underside of where I installed my first flipper mechanism. My next steps are to install the Pine64 SBC that will run this prototype, make some power and bus bars, and come up with a bracket that will support the solenoid and connect to the flipper mechanism. That being said, for the next 11 days I will be on vacation. I’m off to see The Proclaimers in Grant’s Pass, Oregon, then drive up the coast, hit Portland, then come back home and get back to work!


Author: homechicken

Dvorak Typist. Mandarin Speaker. Mugwump. Commander of Her Royal Majesty's 102nd Garden Gnome Regiment. Collector of Hobbies. Cat Whisperer. Maker of Things.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s